For High-Speed Milling of Aluminum
| DIAMETER |
FEED PER TOOTH |
STARTING RPM |
| 1/8 |
.001 |
12,000 |
| 3/16 |
.002 |
10,000 |
| 1/4 |
.003 |
10,000 |
| 5/16 |
.004 |
8,000 |
| 3/8 |
.005 |
8,000 |
| 1/2 |
.006 |
8,000 |
| 5/8 |
.007 |
6,000 |
| 3/4 |
.008 |
4,000 |
| 1 |
.010 |
4,000 |
*NOTE: If the Cutting Length exceeds 1-1/2 times
the Diameter Size of the tool,
conventional milling is recommended.
| WARNING: |
Too low of an RPM coupled with too
much Feed
might cause the Tool to shatter. |
| FOR BEST RESULTS: |
Direct multiple coolant nozzles at the End Mill to assure constant
cooling of the tool and to flush chips |
Use
the following PDF Sheet for an easy print-out form of the above.
SPEEDS & FEEDS:
2FL, 55deg (PDF)
|
